Stiga 1171 HST Bedienungsanleitung

STIGA ROYAL LINE966 D1171 HST1381 HST8218-2222-70BRUKSANVISNINGKÄYTTÖOHJEETBRUGSANVISNINGBRUKSANVISNINGGEBRAUCHSANWEISUNGINSTRUCTIONS FOR USEMODE D’EM

61 ENGLISHEN3.7 GEAR LEVER/SPEED LEVERManual, see fig. 6.HST, see fig. 7.1. Set the lever in a suitable position to simply fit the angle link (L) into

62 ENGLISHEN4.18 SHOES (13)Used to set the height of the auger housing above the ground.4.19 WHEEL LOCK4.19.1 HSTSee fig. 8. Machines with hydrostat a

63 ENGLISHEN5.5 STARTING THE ENGINE (WITH ELECTRICAL START)Do not touch engine components because they are warm during use. Risk of burn injuries.Neve

64 ENGLISHEN5.9 AFTER USE1. Check for loose or damaged parts. If required, change damaged parts.2. Tighten loose screws and nuts.3. Brush all the s

65 ENGLISHEN6.6.4 Chute worm gearSee fig. 13.If the discharge chute is difficult to operate, first lubricate the pinion gear (B) and ring gear (A). If

66 ENGLISHEN7.4 THE AUGER BELT7.4.1 Replacing the auger beltMan, see fig. 18, 19.HST, see fig. 20, 21.1. Remove the ignition key.2. Loosen the screw

67 ENGLISHEN7.7 ADJUSTING THE CONTROL WIRESWhen the belts are adjusted or replaced, the control wires must also be checked/adjusted (see below).7.7.1

68 ENGLISHEN7.11 HEADLAMP BULBOnly 27 W original spare part bulb is allowed to be used. Bulbs with higher power will damage the headlamp.The headlamp

www.stiga.comGGP Sweden AB · Box 1006 · SE-573 28 TRANÅS

2 654321789101112131415 16 17 18 19 202122.ADEF123

3GLMManKJ123457MLHST468579

4ABC568323101214111315

512ManABCDEFGHIHSTJABELGIEManHSTELJ161820171921

6HST12 - 13 mm12ManManMNOMQMan222426232527

7Man45684Man8714131371717ManAECBDMan28302931

59 ENGLISHEN1 SYMBOLSThe following symbols appear on the machine. They are there to remind you of the care and attention required in use. This is what

60 ENGLISHEN• Never drive across a slope. Move from the top down, and from the bottom to the top. Be careful when changing direction on a slope. Avoid